Door - Front: Door: Installation

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Have an assistant to aid in removal/installation.

Support the front door (1) with a suitable lifting device.
Position and align the door hinge studs with the upper and lower hinge brackets.
Push the door in towards (1) the vehicle to seat the studs into the hinge brackets.

Courtesy of CHRYSLER GROUP, LLC
Install and tighten the nuts (1, 3) that secure the door hinges to the front door to the proper torque specifications using the following sequence. Refer to TORQUE SPECIFICATIONS .
1. Tighten the upper nut on the lower hinge.
2. Tighten the lower nut on the upper hinge.
3. Tighten the lower nut on the lower hinge.
4. Tighten the upper nut on the upper hinge.
Remove the lifting device supporting the door.
Carefully pull the body wire harness connector(s) (2) out from the A-pillar far enough to reconnect them to the door wire harness boot and connector.
Engage the front door wire harness boot and connector (2) into the wiring clearance hole on the outside of the lower A-pillar.
Reconnect the battery negative cable.
NOTE:
For vehicles equipped with the optional Automatic Express Up power window feature, recalibration of this feature is required whenever power to the door module is disrupted.
Adjust the door hinge positions as necessary to achieve proper door spacing and operation. Refer to DOOR, ADJUSTMENTS .

Courtesy of CHRYSLER GROUP, LLC
Remove the tape strip (1) from the rear edge of front fender.