Panel, Rear Door Trim, Police: Installation

Courtesy of CHRYSLER GROUP, LLC

Prior to installation, check to be certain that all snap retainers are in good condition on the door trim panel and the door's carrier plate. Replace if necessary.
Position the door trim panel near the door. Do not install at this time.
Connect the map light harness (1).

Courtesy of CHRYSLER GROUP, LLC
Using firm pressure, engage the door trim snap retainers (1, 2) into the door's carrier plate.

Courtesy of CHRYSLER GROUP, LLC
Install the screw (1) just behind the armrest. Tighten the screw to 2 N.m (16 in. lbs.).
Connect and install the power window switch. Refer to SWITCH, POWER WINDOW, INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Install the trim plate (1) just behind the armrest.
NOTE:
For vehicles equipped with the optional Automatic Express Up power window feature, calibration of this feature is required whenever power to the door module is disrupted.

A battery reconnect procedure must be performed anytime the battery has been disconnected.
Connect the battery negative cable.