Pressure Bleeding Method: Notes
NOTE:
Follow pressure bleeder manufacturer's instructions for use of pressure bleeding equipment.
- Remove the filler cap from the top of the fluid reservoir (2) on the master cylinder.
- Install Adapter (1) (special tool #6921, Cap, Master Cylinder), in the caps place on the reservoir (2).
- Attach Bleeder Tank C-3496-B, or equivalent, to Adapter (special tool #6921, Cap, Master Cylinder) (1). Pressurize the system following the pressure bleeder manufacturer's instructions.NOTE:
To make sure all air is bled from the ICU or junction block in a timely manner, it is recommended to raise the rear of the vehicle approximately 5° higher than the front or approximately 254-305 mm (10 -12 inches) as measured at the rear bumper (1).
- Raise and support vehicle placing rear of vehicle approximately 5° higher than the front or if measured at the rear bumper (1), approximately 10-12 inches above level. It will be necessary to add extra support stands under vehicle to support this angle.
NOTE:
Use the following wheel circuit sequence for bleeding the brake hydraulic system to adequately remove all trapped air from the brake hydraulic system.
- Right rear wheel
- Left rear wheel
- Right front wheel
- Left front wheel