Rotor, Brake: Installation: Front-SRT8

NOTE:

Installation process is the same for both sides of the vehicle.

NOTE:

Six piston braking system shown in illustration, four piston braking system similar.

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Inspect brake pads before installation. Refer to PADS, BRAKE, INSPECTION .

Clean hub face to remove any dirt or corrosion where rotor mounts.
Install brake rotor (1) onto the hub (2).

Courtesy of CHRYSLER GROUP, LLC
Install the brake caliper assembly (4) to the knuckle.
Install the brake caliper to knuckle bolts (3), and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
Install the tire and wheel assembly. Refer to INSTALLATION .
Remove support and lower the vehicle.
Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
Check and adjust brake fluid level in reservoir as necessary.
CAUTION:
If NEW brake rotors or pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first brake applications following installation.
Road test the vehicle and make several stops to seat the brake pads to the rotor. Refer to PADS, BRAKE, STANDARD PROCEDURE .