LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Rotor, Brake >> Installation >> Rear-SRT8

Rotor, Brake: Installation: Rear-SRT8

NOTE:

Installation process is the same for both sides of the vehicle.

GC0170476Courtesy of CHRYSLER GROUP, LLC
NOTE:

Inspect brake pads and parking brake shoes before installation. Refer to PADS, BRAKE, INSPECTION .

  1. Clean hub face to remove any dirt or corrosion where rotor mounts.
  2. Install brake rotor (1) onto the hub (3).
    GC0170404Courtesy of CHRYSLER GROUP, LLC
  3. Install the brake caliper assembly (2) to the knuckle.
  4. Install the brake caliper adaptor to knuckle bolts (3). Tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  5. Remove jack from under spring link.
  6. Install the tire and wheel assembly. Refer to INSTALLATION .
  7. Remove support and lower the vehicle.
  8. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
  9. Check and adjust brake fluid level in reservoir as necessary.
    CAUTION:

    If NEW brake rotors or pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first brake applications following installation.

  10. Road test the vehicle and make several stops to seat the brake pads to the rotor. Refer to PADS, BRAKE, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals