LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tires & Wheels (Service Information) >> Wheels >> Stud, Wheel, Front >> Installation

Stud, Wheel, Front: Installation

  1. Install the new stud into the hub flange.
  2. Install three washers onto the stud, then install the lug nut with the flat side of the nut against the washers.
  3. Tighten the lug nut until the stud is pulled into the hub flange. Verify that the stud is properly seated into the flange.
  4. Remove the lug nut and washers.
  5. Install brake rotor and caliper. Refer to ROTOR, BRAKE, INSTALLATION .
  6. Install the tire and wheel assembly, using a NEW  lug nut on the stud that was replaced. Refer to INSTALLATION .
  7. Remove support and lower the vehicle.
scientia non olet · About LEMON Manuals