LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Theft Security (Service Information) >> Description >> Sentry Key Immobilizer System

Sentry Key Immobilizer System

The Sentry Key Immobilizer System (SKIS) is factory-installed standard equipment on this model. The SKIS provides passive vehicle protection, immobilizing the vehicle by preventing the engine from operating unless a valid electronically encoded key or FOB with Integrated Key (FOBIK) is detected. In vehicles equipped with the Passive Entry Keyless Go (PEKG) system, a valid encoded key or FOBIK must only be present somewhere within the passenger compartment of the vehicle for the engine to continue to operate.

NOTE:

Charger Pursuit vehicles also have a unique Secure Park feature that will prevent the transmission gear selector of a vehicle left idling from being shifted out of Park (P  ) or moving more than about 0.9 meters (3 feet) if there is no valid FOBIK detected within the interior of the vehicle. This feature can be enabled using a diagnostic scan tool. Once enabled, it is activated or deactivated by depressing the center remote radio button on the back of the steering wheel. While this feature is passive and does prevent vehicle theft, it actually relies primarily upon features of the Keyless Go (KG) portion of the PEKG system, which is discussed in further detail elsewhere within this service information. Refer to MODULE, RADIO FREQUENCY (RF HUB), OPERATION .

The Radio Frequency Hub (RFH) is the primary component of the SKIS. It is also the receiver for the Remote Keyless Entry (RKE) system, the Keyless Go (KG) system, the Passive Entry (PE) system and the Remote Start system on vehicles so equipped. The RFH is located near the center of the shelf support behind the rear seat back and is concealed beneath the package tray interior trim.

The Keyless Ignition Node (KIN) includes the integral ignition switch push button. The KIN is located in the instrument panel, just to the right of the steering column. The remainder of the KIN including its mounting provisions and electrical connections are concealed within the instrument panel.

The SKIS includes the following major components, which are described in further detail elsewhere in this service information:

The PCM and the RFH each contain a microcontroller and programming that allow them to communicate with each other and other electronic modules in the vehicle using the Controller Area Network (CAN) data bus. In addition, the KIN and the RFH communicate with each other using a Local Interface Network (LIN) data bus. Refer to COMMUNICATION, DESCRIPTION .