Sensor, Wheel Speed, Front: Removal: All-Wheel-Drive

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove inner wheel liner. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
Remove sensor cable from routing clip that is attached to the brake hose bracket.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
To release sensor connector from body wiring harness connector in following step, slide release tab back, then separate electrical connector (2).
Remove sensor connector (2) from body.

Courtesy of CHRYSLER GROUP, LLC
Remove screw (1) fastening wheel speed sensor (2) to knuckle (4). Pull sensor head out of knuckle.
Remove wheel speed sensor cable routing clip (3) from knuckle (4) and discard. The clip is one time use only and must be replaced if removed.
Remove wheel speed sensor (2).