Sensor, Wheel Speed, Front: Installation: Installation
NOTE:
Installation process is the same for both sides of the vehicle.
- Install the Wheel Speed Sensor (WSS). Tighten the wheel speed sensor head to knuckle bolt (2) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Attach WSS to the brake hose routing bracket (1).
- Install the WSS harness isolators to the routing brackets (1 and 3).
- Connect the WSS harness to the body connector (2) and make sure retaining clip is properly in place and sensor connector cannot be pulled out.
- Install wheel liner. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
- Remove the support and lower the vehicle.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Perform Verification Test and clear any faults. Refer to STANDARD PROCEDURE .
