Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. Turn the ignition on.
2. With the scan tool, read RF Hub DTCs and record on the repair order.
3. Turn the ignition off and wait 30 seconds.
4. Turn the ignition on and attempt to start the engine.
5. If the engine started, wait 10 seconds then turn the ignition off.
6. Turn the ignition on.
7. With the scan tool, read RF Hub DTCs.

   Is the DTC active?

   Yes 

   • Replace the Keyless Ignition Node in accordance with the Service Information. Refer to MODULE, KEYLESS IGNITION NODE (KIN), REMOVAL .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension and repair as necessary. If no problems are found, test complete. If the DTC ever repeats, replace the Keyless Ignition Node in accordance with the Service Information. Refer to MODULE, KEYLESS IGNITION NODE (KIN), REMOVAL .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .