Converter, Catalytic: Removal: 6.2L/6.4L
CAUTION:
When separating the catalytic converters from the manifolds, disconnect the oxygen sensor connectors. Allowing the catalytic converters to hang from the oxygen sensor wires damages the harness or sensors.
- Disconnect and isolate the negative battery cable.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Saturate all exhaust bolts and nuts with Mopar® Rust Penetrant. Allow five minutes for penetration.
- Disconnect the oxygen sensor wire harness connector.
- Remove the catalytic converter to manifold flange nuts (2) and separate the catalytic converters (1) from the exhaust manifolds.
- Loosen the front exhaust pipe to muffler and resonator assembly band clamps (1).
- Separate the muffler and resonator assembly from the catalytic converters.
- Remove the left (1) and/or right (2) catalytic converters.
