LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Converter, Catalytic >> Installation >> 3.6L

Converter, Catalytic: Installation: 3.6L

GC0170057Courtesy of CHRYSLER GROUP, LLC
  1. Position new exhaust gasket onto flange.
  2. Position the front exhaust pipe/catalytic converter assemblies into vehicle.
  3. Install the lower bolts (3, 4) at the exhaust flange. Do not tighten.
  4. Lower vehicle.
  5. Install the upper exhaust flange bolts (1, 2) and tighten the flange bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  6. Tighten lower flange bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
    GC0170115Courtesy of CHRYSLER GROUP, LLC
  7. Insert the front exhaust pipe/catalytic converter assembly into the exhaust pipe/muffler and resonator assembly.
  8. Position the exhaust system for proper clearance with the frame and underbody parts. A minimum clearance of 25.4 mm (1.0 in.) is required.
  9. Tighten the band clamp nuts (1, 2) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  10. Install the support bracket bolts (3) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  11. Connect oxygen sensor electrical connectors.
  12. Lower the vehicle.
  13. Start the vehicle and inspect for exhaust leaks. Repair exhaust leaks as necessary.
scientia non olet · About LEMON Manuals