Resonator, Exhaust: Installation: 3.6L/5.7L
- Place the resonator/tailpipe assembly into position.
- Install the two rear isolator mounting bolts (1).
- Install the front isolator mounting bolt (1).
- Install the flange nuts (2) and tighten finger tight.
- Check the clearance between muffler and tailpipe assembly and the fuel tank. Clearance is 14mm (.55 in.) for V8 engine and 16mm (.62 in.) for V6 engine.
- Check the clearance at rear tunnel reinforcement. Clearance is 15 - 20mm (.59 -.78 in.).
- The tailpipe should be centered in the rear fascia opening.
- Tighten the flange nuts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Lower the vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
