LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension & Wheel Alignment >> Front >> Shock Absorber, Suspension, Coil-Over >> Removal >> SRT

Shock Absorber, Suspension, Coil-Over: Removal: SRT

NOTE:

Removal process is the same for both sides of the vehicle.

GC0170119Courtesy of CHRYSLER GROUP, LLC
  1. If removing right front strut, remove the supercharger coolant recovery reservoir. Refer to RESERVOIR, COOLANT, REMOVAL .
  2. If equipped, remove front shock tower cap from top of shock assembly.
  3. Remove three nuts (2) fastening shock assembly to shock tower (1).
  4. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  5. Remove the tire and wheel assembly. Refer to REMOVAL .
  6. Remove front splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
    GC0170083Courtesy of CHRYSLER GROUP, LLC
  7. Remove the stabilizer link to strut nut (1). Slide stabilizer link (2) from shock assembly (5).
  8. Remove the strut to lower control arm bolt (4).
    GC0170518Courtesy of CHRYSLER GROUP, LLC
  9. Disconnect the Active Damping System (ADS) shock connector (1) from the harness on the wheel well.
  10. Remove the upper ball joint from the knuckle. Refer to ARM, UPPER CONTROL, REMOVAL .
  11. Tip top of knuckle outward using care not to overextend brake flex hose.
  12. Remove shock assembly from vehicle.
scientia non olet · About LEMON Manuals