Belt, Serpentine: Installation: 3.6L
- Check the condition of all of the pulleys.CAUTION:
When installing the serpentine accessory drive belt, the belt MUST be routed correctly. If not, the engine may overheat due to the water pump rotating in the wrong direction.
- Install the new belt (3). Route the belt around all pulleys except the idler pulley (2). Rotate the tensioner arm (7) until it contacts its stop position. Route the belt (3) around the idler (2) and slowly let the tensioner (7) rotate into the belt. Make sure the belt (3) is seated onto all pulleys.
- With the drive belt installed, inspect the belt wear indicator. The gap between the tang and the housing stop (measurement A) must not exceed 24 mm (.94 inches).
- Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
