Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| A/C Compressor to Engine | Specific fastener placement and torque pattern required. Refer to COMPRESSOR, A/C, INSTALLATION . | |||
| A/C Condenser to Radiator Bolts | 5 | - | 44 | |
| A/C Expansion Valve to Evaporator Tube Tapping Block Bolts | 11 | 8 | - | |
| A/C Liquid Line to Internal Heat Exchanger (IHX) Nut | 20 | 15 | - | |
| Compressor Shaft Bolt | 19 | 14 | - | |
| Fresh Air Inlet Housing to Dash Panel Nuts | 7 | - | 62 | |
| HVAC Housing to Engine Side of Dash Panel Nuts | 7 | - | 62 | |
| Internal Heat Exchanger (IHX) Line to Expansion Valve Nut | 20 | 15 | - | |
| Liquid Line Front to Rear Section Nut | 22 | 16 | - | |
| Liquid Line Internal Heat Exchanger (IHX) Nut | 20 | 15 | - | |
| Refrigerant Lines to A/C Expansion Valve Nut | 23 | 17 | - | |
| Refrigerant Line to A/C Compressor Nut | 23 | 17 | - | |
| Refrigerant Line to A/C Condenser Nut | 22 | 16 | - | |
| Refrigerant Line Bracket to Strut Tower Bolt | 11 | 8 | - | |
| Receiver/drier to A/C Condenser Bolt | 22 | 16 | - | |
| Receiver/drier Bracket to A/C Condenser Screw | 5 | - | 44 | |
| Suction Line to Internal Heat Exchanger (IHX) Nut | 20 | 15 | - | |
| Suction Line Front to Rear Section Nut | 22 | 16 | - | |
| Strut Support to Strut Tower Bolts | 38 | 28 | - | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||