Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read the Body Control Module (BCM) DTCs and record on the repair order.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE TRANSMISSION CONTROL MODULE (TCM)
1. Turn the ignition off.
2. Disconnect the TCM harness connector.
3. Turn the ignition on.
4. With the scan tool, read the BCM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 3
  No
  - Replace the Transmission Control Module (TCM) in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL .
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to the appropriate Diagnostic information. .
CHECK THE (F1) IGNITION OFF/RUN/START CONTROL CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the BCM C5/E harness connector.
3. Check for continuity between ground and the (F1) Ignition Off/Run/Start Control circuit at the BCM C5/E harness connector.
  Is there continuity between ground and the (F1) Ignition Off/Run/Start Control circuit?
  
  Yes
  - Repair the short to ground in the (F1) Ignition Off/Run/Start Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .