LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Plumbing >> Condenser, A/C >> Removal

Condenser, A/C: Removal

WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

GC0144895Courtesy of CHRYSLER GROUP, LLC
NOTE:

Illustration shown with A/C condenser and radiator removed from vehicle for clarity.

  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
  4. Disconnect the automatic transmission cooler lines from the automatic transmission cooler ports (1) and install plugs in the cooler ports.
  5. Disconnect the A/C discharge line and A/C liquid line from refrigerant line fittings (3 and 5). Refer to LINE, A/C LIQUID, REMOVAL  and LINE, A/C DISCHARGE, REMOVAL .
  6. Install plugs in, or tape over, the opened refrigerant line fittings and condenser ports.
  7. Remove the four bolts (2, 4, 7 and 9) that secure A/C condenser (6) to the radiator (10).
  8. Carefully tilt the bottom of the A/C condenser forward and lower the condenser out of the vehicle.
  9. If required, place the A/C condenser onto a workbench and remove the A/C receiver/drier (8). Refer to DRIER, A/C RECEIVER, REMOVAL .
scientia non olet · About LEMON Manuals