LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.7L Engine (Service Information) >> Cylinder Head >> Cover(S), Cylinder Head >> Installation

Cover(S), Cylinder Head: Installation

GC0139403Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.

CAUTION:

Do not allow other components including the wire harness to rest on or against the engine cylinder head cover. Prolonged contact with other objects may wear a hole in the cylinder head cover.

NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.

  1. Clean the cylinder head cover (1) and the sealing surface of the cylinder head (2). Inspect and replace gasket if necessary.
  2. Install the cylinder head cover (1) and tighten bolts finger tight.
    GC0080292Courtesy of CHRYSLER GROUP, LLC
  3. Using the sequence shown, tighten the cylinder head cover bolts to 8 N.m (71 in. lbs.).
  4. Install the ignition coils. Refer to COIL, IGNITION, INSTALLATION, 5.7L/6.4L .
    GC0143807Courtesy of CHRYSLER GROUP, LLC
  5. Install the engine cover (2).
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals