LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System (Service Information) >> Starter >> Installation >> 5.7L / 6.4L

5.7L / 6.4L

  1. Position the starter into transmission but do not install bolts.
    GC0170166Courtesy of CHRYSLER GROUP, LLC
  2. Connect the solenoid harness connector (1) to starter motor (snaps on). Tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  3. Position the battery cable (1) to solenoid stud. Install and tighten the battery cable eyelet nut to the proper torque specification. Refer to TORQUE SPECIFICATIONS . Do not allow the starter motor to hang from wire harness.
    GC0170079Courtesy of CHRYSLER GROUP, LLC
  4. Install and tighten two mounting bolts (1). Tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  5. Install the starter heat shield (if equipped). Tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
    GC0170316Courtesy of CHRYSLER GROUP, LLC
  6. Connect the electronic power steering connector (1).
  7. Connect the negative battery cable. Tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals