Manifold, Intake: Removal
WARNING: This page is about a different variant/trim than selected.
- Perform the fuel system pressure release procedure. Refer to FUEL DELIVERY, GAS, STANDARD PROCEDURE .
- Disconnect and isolate the negative battery cable.
- Remove the engine covers (1).
- Disconnect the fuel supply line. Refer to FITTING, QUICK CONNECT, STANDARD PROCEDURE .
- Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
- Disconnect the brake booster hose and the vapor purge hose.
- Disconnect the wire harness connectors from the following components:
- Manifold Absolute Pressure (MAP) Sensor
- Short Runner Valve (SRV)
- Fuel Injectors
- Electronic Throttle Control (ETC)
- Using the sequence shown, remove the intake manifold retaining bolts.
- Remove the intake manifold and throttle body as an assembly from the vehicle.
