Positive - Battery To Bulkhead
- Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.
- Remove the spare tire cover to gain access to the battery.
- Disconnect and isolate the negative battery cable at the Intelligent Battery Sensor (IBS) M8 stud (1).
- Disconnect the battery positive cable.
- Remove the Power Distribution Center (PDC) cover (2).
- Remove the battery positive cable to the rear PDC fastener (3).
- One at a time, free the battery positive cable from the routing clips located in the rear compartment area.
- Remove the right front seat. Refer to SEAT, FRONT, REMOVAL .
- Remove the right rear seat cushion. Pull upward at forward edge of each retainer loop of the rear seat cushion to disengage retainer loops from cups in floor.
- Remove the right front and rear door sill trim panels.
- Remove the right B - pillar lower trim panel. Refer to PANEL, B-PILLAR TRIM, REMOVAL .
- Position carpet aside to gain access to the battery positive cable.
- One at a time, free the battery positive cable from the routing clips located in the rear seat area.
- Position the bulkhead insulator aside to gain access to the battery positive cable bulkhead fastener.
- Remove the battery positive cable to bulkhead fastener.
- Remove the battery positive cable from the vehicle making note of the cable routing under the floor cross members.
