Stabilizer Bar, Rear Suspension: Removal

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the tire and wheel assembly. Refer to REMOVAL .
Remove the rear crossmember assembly. Refer to CROSSMEMBER, TRANSMISSION, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Mark the location of the stabilizer bushings prior to removing the stabilizer bar bushing clamps, this will be essential for the installation process.
On each end, remove the stabilizer link to stabilizer bar bolt and nut (2).
Remove the four stabilizer bar bushing retainer bolts(1) and retainer brackets.
Remove stabilizer bar with bushings and retainers.
Remove retainers from bushings.
Remove bushings from stabilizer bar utilizing slits in bushings.