Starting System (Service Information): Starter: Removal: 3.6L
- Disconnect and isolate the negative battery cable at the battery.
- Secure the steering wheel.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Disconnect the steering gear intermediate shaft (1). Refer to SHAFT, INTERMEDIATE, LOWER, REMOVAL
.
- Remove the starter solenoid heat shield.
- Disconnect the starter solenoid electrical connector (1) from the starter solenoid terminal.
- Remove the battery cable nut and battery cable from the solenoid stud (2).
- Remove the starter mounting bolts (4), the electrical harness mounting bracket should remain in position.
- Rotate and remove the starter assembly (3) from the transmission.
