LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control Module (BCM) - DTCS B1830-11 To U1433-24 >> DTC Troubleshooting >> U0011-00-Can Interior Bus Off Performance >> Can Bus Voltages (Normal Operation)

Can Bus Voltages (Normal Operation)

CAN C Bus Voltages (Normal Operation)
CAN C Circuits Sleep Recessive (Bus Idle) Dominant (Bus Active) CAN (-) Short to Ground CAN (+) Short to Ground CAN (-) Short to Voltage CAN (+) Short to Voltage CAN (+) Short to CAN (-)
CAN (-)  0 V 2.4 - 2.5 V 1.3 - 2.3 V 0 V 0.3 - 0.5 V Battery Voltage Battery Voltage Less 0.75 V 2.45 V
CAN (+)  0 V 2.4 - 2.5 V 2.6 - 3.5 V 0.02 V 0 V Battery Voltage Less 0.75 V Battery Voltage 2.45 V
CAN IHS Bus Voltages (Normal Operation)
CAN IHS Circuits Key-Off (Bus Asleep) Key-On (Bus Active) CAN (-) Short to Ground CAN (+) Short to Ground CAN (-) Short to Voltage CAN (+) Short to Voltage CAN (+) Short to CAN (-)
CAN (-)  0.0 V 1.3 - 2.3 V 0 V 0.3 - 0.5 V Battery Voltage Battery Voltage Less 0.75 V 2.45 V
CAN (+)  0.0 V 2.6 - 3.5 V 0.02 V 0 V Battery Voltage Less 0.75 V Battery Voltage 2.45 V
Notes 
All measurements were taken between a node ground and a CAN Bus terminal, using a standard DVOM.
The DVOM will display the average network voltage.
Total resistance of the CAN Bus networks should be measured with the battery, and auxiliary battery (if equipped with Engine Stop/Start), disconnected. The normal average CAN Bus resistance is approximately 60 Ohms.
 
 
 
scientia non olet · About LEMON Manuals