Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

PROGRAM THE POWERTRAIN CONTROL MODULE

NOTE:

Diagnose any Camshaft Position and Crankshaft Position Sensor DTCs before continuing.

Verify the PCM is at the latest calibration (flash level).
NOTE:
An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.
If a PCM has later calibration available, program the PCM in accordance with the Service Information. and follow the PCM/ECM PROGRAMMING procedure. Refer to MODULE, POWERTRAIN CONTROL (PCM), MODULE PROGRAMMING .
Start the engine.
Allow the engine to reach normal operating temperature.
Operate the accelerator pedal. (do not exceed 3500 rpm).
With the scan tool, select View DTCs.
NOTE:
Diagnose any other DTCs that may have set with the P061C.

Does this DTC reset by itself?

Yes
- Replace and reprogram the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Test Complete.