LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (6.2L - DTCS P0140 To P0452) >> DTC Troubleshooting >> P025C-Fuel Pump Module Control Circuit Low >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different variant/trim than selected.
  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    If DTC P0627 is present, repair that DTC before proceeding with this test.

    1. Turn the ignition on.
    2. With the scan tool, read DTCs.

      Is the DTC active?

      Yes 

      • Go To  2

      No 

  2. CHECK THE FUEL PUMP (N1) RELAY OUTPUT CIRCUIT FOR A SHORT TO GROUND 
    1. Turn the ignition off.
    2. Disconnect the FPCM harness connector.
    3. Remove the Fuel Pump Relay.
    4. Check for continuity between ground and the Fuel Pump (N1) Relay Output circuit at the FPCM harness connector.

      Is there continuity between ground and the Fuel Pump (N1) Relay Output circuit?

      Yes 

      • Repair the Fuel Pump (N1) Relay Output circuit for a short to ground.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .

      No 

      • Go To  3
  3. CHECK THE FUEL PUMP (N1) RELAY OUTPUT CIRCUIT FOR AN OPEN OR HIGH RESISTANCE 
    1. Check for continuity of the Fuel Pump (N1) Relay Output circuit between the FPCM harness connector and the terminal 87 of the Fuel Pump Relay connector in the PDC.

      Is the resistance below 3.0 Ohms?

      Yes 

      • Go To  4

      No 

      • Repair the Fuel Pump (N1) Relay Output circuit for an open or high resistance.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  4. FUEL PUMP CONTROL MODULE 
    1. Reconnect the Fuel Pump relay.
    2. Turn the ignition on, engine not running.
    3. With the scan tool, begin the Variable Speed Fuel Pump Relay Actuation Test.
    4. Measure the voltage between ground and the Fuel Pump (N1) Relay Output circuit at the FPCM harness connector.

      Is the voltage equal to battery voltage?

      Yes 

      • Replace the Fuel Pump Control Module in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .

      No 

      • Replace the Fuel Pump Relay in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
scientia non olet · About LEMON Manuals