LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> MODULE, Radio RECEIVER >> Removal

MODULE, Radio RECEIVER: Removal

GC0170269Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
  2. Remove the instrument cluster bezel from the instrument panel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
  3. Remove the four screws (1) that secure the Radio to the instrument panel support structure (2).
  4. Pull the Radio out from the instrument panel far enough to access the connections at the back of the Radio.
    GC0162395Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the antenna connectors (3) and the instrument panel wire harness connector (2) from the back of the Radio.
  6. If equipped, disconnect the Universal Serial Bus (USB) connector (1) from the back of the Radio.
  7. Remove the Radio from the instrument panel.
scientia non olet · About LEMON Manuals