Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

PCM ODOMETER MILEAGE NOT PROGRAMMED

Turn the ignition on.
If a PCM has later calibration available, program the PCM in accordance with the Service Information. and follow the PCM/ECM PROGRAMMING procedure. Refer to MODULE, POWERTRAIN CONTROL (PCM), MODULE PROGRAMMING .
With the scan tool, erase DTCs.
Start the engine.
Allow the engine to reach normal operating temperature.
With the scan tool, read DTCs.
Is the DTC active?

Yes
- Replace and program the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- The SRI mileage has been successfully programmed into the PCM. Test is complete.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .