Air Cleaner: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the air cleaner element (1) into the housing.
- Align the air cleaner housing cover locating tabs into the housing while lowering the cover into position.
- If removed, insert air cleaner housing cover into the air inlet tube and tighten the clamp (1) to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install the air cleaner housing cover retaining screws (3) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Connect the Inlet Air Temperature (IAT) sensor wire harness connector (2).
- Connect the negative battery cable.
