LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (6.2L Engine (Service Information)) >> Supercharger System >> Supercharger >> Installation >> Installation

Supercharger System: Supercharger: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:

The supercharger assembly will require the help of an assistant(s) to install the assembly into the engine compartment.

  1. Inspect the seals and replace if necessary.
  2. Position the supercharger assembly onto the cylinder heads, aligning the dowels in the supercharger with the holes cylinder head.
    GC0170323Courtesy of CHRYSLER GROUP, LLC
  3. Using the sequence shown, Install the supercharger retaining bolts and tighten all retaining bolts as follows:
    • First tighten all bolts, using the sequence, to 5 N.m (4 ft. lbs.).
    • Next tighten all bolts, using the sequence, to 15 N.m (11 ft. lbs.).
    • Finally tighten all bolts, using the sequence, to 30 N.m (22 ft. lbs.).
    GC0170062Courtesy of CHRYSLER GROUP, LLC
  4. Connect the fuel supply line (1) to the fuel rail (2). Refer to FITTING, QUICK CONNECT, STANDARD PROCEDURE .
    GC0170562Courtesy of CHRYSLER GROUP, LLC
  5. Install the Low Temperature Radiator (LTR) circuit hoses to coolant crossover (1).
    NOTE:

    Use previous markings to determine hose location.

  6. Connect the wire harness connector to the charger air cooler temperature sensor, located on the crossover tube.
    GC0170413Courtesy of CHRYSLER GROUP, LLC
  7. Connect the fuel injector wire harness connectors (1) on both sides of supercharger.
    GC0170238Courtesy of CHRYSLER GROUP, LLC
  8. Connect the wire harness connector (2) to the intermediate Temperature-Manifold Absolute Pressure (TMAP) sensor (1).
    GC0170459Courtesy of CHRYSLER GROUP, LLC
  9. Connect the wire harness connector (2) to the bank two TMAP sensor (3).
    GC0170093Courtesy of CHRYSLER GROUP, LLC
  10. Connect bank one (1) and throttle outlet (2) TMAP sensor wire harness connectors.
  11. Connect the wire harness connector to the throttle body at nose of supercharger.
  12. Connect the bypass valve wire harness connector (3).
    GC0170176Courtesy of CHRYSLER GROUP, LLC
  13. Install the Positive Crankcase Ventilation (PCV) hose (1) to the right side of supercharger nose (2).
    GC0170301Courtesy of CHRYSLER GROUP, LLC
  14. Install the fuel purge hose (2) to the top of the supercharger nose (1).
  15. Install the brake booster hose, located under the nose of the supercharger.
  16. Install the supercharger belt. Refer to BELT, DRIVE, INSTALLATION .
    GC0170121Courtesy of CHRYSLER GROUP, LLC
  17. Install the engine covers.
  18. Install the air cleaner body Refer to BODY, AIR CLEANER, INSTALLATION  .

    .

  19. Install the cowl cover panel. Refer to COVER, COWL PANEL, INSTALLATION .
  20. Fill the cooling system. Refer to STANDARD PROCEDURE .
    NOTE:

    Evacuating or purging air from the charge air cooling system must be done with the use of a pressurized air operated vacuum generator.

  21. Connect the negative battery cable.
scientia non olet · About LEMON Manuals