Insulator, Engine Mount, Rear: Removal: RWD
WARNING: This page is about a different variant/trim than selected.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the two bolts (2) from the rear engine mount isolator.
- Using a suitable jack stand and a block of wood positioned under the transmission oil pan, raise the transmission until the weight is off of the isolator (approximately 5 mm).
- Remove four bolts (3) and the crossmember (1).
- Remove four bolts (2) and the rear engine mount isolator (1).
- If required, remove four bolts (1) and the rear engine mount bracket (2).
