LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (3.6L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Rear >> Installation >> RWD

Insulator, Engine Mount, Rear: Installation: RWD

WARNING: This page is about a different variant/trim than selected.
GC0095620Courtesy of CHRYSLER GROUP, LLC
  1. If removed, install the rear engine mount bracket (2) and securely tighten the four bolts (1) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0144303Courtesy of CHRYSLER GROUP, LLC
  2. Install the rear engine mount isolator (1) and tighten the four bolts (2) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0152303Courtesy of CHRYSLER GROUP, LLC
  3. Install the crossmember (1) and tighten the four bolts (3) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  4. Lower the transmission so the weight is resting on the isolator.
  5. Install two bolts (2) to the rear engine mount isolator and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals