Nozzle, Washer: Installation
- Position the washer nozzle to the mounting hole on the rear surface of the inner hood reinforcement.
- Insert the washer nozzle nipple and extension tube through the mounting hole far enough to engage the integral locating tabs (3) of the nozzle with the lower edge of the mounting hole.
- Index the locating ridge (2) on the nozzle body to the upper edge of the mounting hole.
- Using hand pressure, push firmly and evenly on the washer nozzle body until the integral latch feature (1) snaps into place within the mounting hole.
- From the underside of the hood, reconnect the washer hose fitting (3) of the under hood wire and plumbing harness (1) to the barbed nipple of the washer nozzle.
- From the underside of the hood, connect the washer nozzle pigtail wire connector (2).
- Install the push-in retainers that secure the rear edge of the hood silencer pad to the inner hood reinforcement.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
