Relay, Wiper, High And Low: Installation
- Refer to the fuse and relay layout map on the underside of the front Power Distribution Center (PDC) cover for the proper wiper high and low relay identification and cavity location.
- Position the wiper high and low relay in the proper cavity within the front PDC.
- Align the relay terminals with the terminal cavities in the PDC.
- Push firmly and evenly on the top of the relay until the terminals are fully seated in the terminal cavities in the PDC.
- Install the cover onto the front PDC.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.