Relay, Wiper, On And Off: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the cover from the front Power Distribution Center (PDC) located ahead of the right strut tower on the right front wheel house splash shield in the engine compartment.
- Refer to the fuse and relay layout map on the underside of the PDC cover for wiper On and Off relay identification and cavity location.
- Remove the wiper On and Off relay by grasping it firmly and pulling it straight out from the cavity within the front PDC.