Reservoir, Windshield Washer: Installation
- Lift the washer reservoir (1) up into the vehicle and position it to the outboard side of the right frame rail (3).
- Install and tighten the two screws (2) that secure the reservoir to the frame rail. Tighten the screws securely.
- Connect the washer hose (2) to the barbed outlet nipple of the washer pump (7).
- Connect the headlamp and dash wire harness (1) connector for the washer pump/motor unit (5) to the connector receptacle on the top of the pump motor.
- Connect the headlamp and dash wire harness connector for the washer fluid level switch (6) to the connector receptacle for the switch (3).
- Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Fill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
