Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. Turn the ignition on.
2. Press and Release the Decklid Release Switch.
3. With the scan tool, read the Body Control Module (BCM) DTCs and record on the repair order.
4. With the scan tool, erase the BCM DTCs
5. Turn the ignition on.
6. Press and Release the Decklid Release Switch several times.
7. Wait at least 12 seconds.

   Did the DTC return?

   Yes 

   • Inspect the Decklid Release Switch for a sticking condition. If no problem is found, replace the Decklid Release Switch in accordance with the Service Information. Refer to SWITCH, DECK LID RELEASE, REMOVAL .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .