Standard Procedure - Fluid/Filter Service

WARNING: This page is about a different variant/trim than selected.

NOTE:

The oil pan and filter are an integrated assembly that cannot be serviced separately.

Courtesy of CHRYSLER GROUP, LLC

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the transmission oil pan plug (1) and drain the transmission fluid.
NOTE:
Inspect the gasket for reuse. If the seal is cut or torn, replace the gasket.

Courtesy of CHRYSLER GROUP, LLC
Remove the 13 oil pan retaining bolts (2).
Remove the oil pan (1) and gasket. If the pan is being removed for contamination concerns discard the pan.
Install the NEW oil pan (1) and gasket.

Courtesy of CHRYSLER GROUP, LLC
Install the 13 oil pan retaining bolts in the sequence shown and tighten to 10 N.m (89 in. lbs.).

Courtesy of CHRYSLER GROUP, LLC
Verify the transmission oil pan plug (1) is installed.
Inspect and adjust the fluid level. Refer to FLUID AND FILTER, STANDARD PROCEDURE .
Lower the vehicle.