LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (8HP70 Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Removal >> Output Shaft Seal

Output Shaft Seal

WARNING: This page is about a different variant/trim than selected.
CAUTION:

Do not allow the propeller shaft to hang from the vehicle unsupported. Damage may occur to the joint, boot, and center bearing from over-angulation.

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0162391Courtesy of CHRYSLER GROUP, LLC
  2. Apply alignment index mark (1) to the transmission flange.
    GC0170214Courtesy of CHRYSLER GROUP, LLC
  3. Remove the drive shaft bolts to transmission flange and position aside the drive shaft. Secure the drive shaft with a strap or equivalent.
    GC0169779Courtesy of CHRYSLER GROUP, LLC
  4. Using a suitable punch, remove the staking (3) from the drive shaft nut (2).
  5. Remove the drive shaft flange nut (2) using a 34 mm 12 point socket (3) and (special tool #C-3281, Holder, Flange) (2) to hold the flange (1).
  6. Remove the flange and flange dust seal.
  7. Remove the output shaft seal with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals