Front Click Noise At Low Speed Turns (05-002-20)

WARNING: This page is about the Charger GT, which is a different variant/trim than selected.

Publication date: 2020-10-21
Reference number: 05-002-20

FRONT CLICK NOISE AT LOW SPEED TURNS

TECHNICAL SERVICE BULLETIN

Reference Number(s): 05-002-20, Date of Issue: October 21, 2020

CHRYSLER:	2020 (WD) Dodge Durango; 2018 - 2020 (WK) Jeep Grand Cherokee; 2018 - 2020 (LD) Dodge Charger; 2018 - 2020 (LA) Dodge Challenger
GROUP:	05 - Brakes

This bulletin involves installing a friction disc kit on both front hub bearings and rotors.

MODELS CHART

NOTE: This bulletin applies to vehicles within the following markets/countries: North America and EMEA.

NOTE: This bulletin applies to vehicles equipped with Brembo 6-Pot Fxd Caliper Brakes (Sales Code BR7) or High Performance Brakes (Sales Code BNN).

The customer may comment on the following:

When making a sharp turn at low speed (parking lot) maneuvers, a click noise is heard. Most of the time the noise can be heard if the windows are open.

If the customer describes the symptom/condition listed above, perform the Repair Procedure.

PARTS INFORMATION

Qty.	Part No.	Description
1	68530288AA	Brake Kit, Friction (LA and LD vehicles)
1	68530289AA	Brake Kit, Friction (WK and WD vehicles)

NOTE: Each kit will contain, four caliper mounting bolts, four friction discs and one tube of adhesive.

Remove both front brake rotors. Refer to the detailed service procedures available in DealerCONNECT/Service Library under: 05 - Brakes/05 - Brakes, Base/Hydraulic/Mechanical/Rotor, Brake/Removal, Front - SRT.
Clean hub face where the rotor surface contacts the hub face to remove any dirt or corrosion, using scotch brite pad or similar style scouring pad that will not scratch the surface. Clean all mounting surfaces as seen in (Fig. 1) .
Use small amount of adhesive between friction disc and hub to hold disc centered on hub (Fig. 2) .
Install the friction disc on to both front hub flanges. (Fig. 3) .
Put both rotors back onto the hubs and apply a small amount of adhesive in the center of he friction disc. Put both friction discs on the outside of the rotors (Fig. 4) .
Finish installing both front brake rotors/calipers. Refer to the detailed service procedures available in DealerCONNECT/Service Library under: 05 - Brakes/05 - Brakes, Base/Hydraulic/Mechanical/Rotor, Brake/Installation, Front - SRT.

Reimbursable within the provisions of the warranty.

TIME ALLOWANCE CHART

Labor Operation No:	Description	Skill Category	Amount
05-21-10-A7	Front Rotors, Clean and Install Friction Discs (0 - Introduction)	6 - Electrical and Body Systems	0.6 Hrs.

FAILURE CODE CHART

ZZ	Service Action