Hydraulic Power Steering
- Install pressure hose in engine compartment from underneath.NOTE:
Always use a
NEW
O-ring on the end of the pressure hose.
- Lubricate new O-ring on steering gear end of pressure hose with clean power steering fluid.
- Install pressure hose (2) to steering gear (1). Do not tighten tube nut at this time.
- Route pressure hose along right side of engine cradle. Position pressure hose (3) routing clamp over return hose (5) routing clamp, then install screw (2) securing hoses to right side of engine cradle (1).
- Route pressure hose along front of engine cradle. Install screw (4) through routing clamp securing hose to front of engine cradle (1).
- Tighten power steering pressure hose nut (2) at steering gear to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install belly pan. Refer to BELLY PAN, INSTALLATION .
- Remove support and lower the vehicle.NOTE:
Always use a
NEW
O-ring on the end of the pressure hose.
- Lubricate new O-ring on power steering pump end of pressure hose with clean power steering fluid.
- Install power steering pressure hose (2) to pump (3). Tighten power steering pressure hose nut to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the air cleaner body and inlet tube. For 3.6L, refer to BODY, AIR CLEANER, INSTALLATION . For 5.7L, refer to BODY, AIR CLEANER, INSTALLATION . For 6.2L, refer to BODY, AIR CLEANER, INSTALLATION . For 6.4L, refer to BODY, AIR CLEANER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Fill and bleed power steering system. Refer to STANDARD PROCEDURE .
