Diagnostic Test
- CHECK FOR AN ACTIVE DTC
- With the scan tool, read ORC DTCs and record on the repair order.
- Record the Environmental Data.
- With the scan tool, erase DTCs.
- Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read ORC DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
- REPLACE THE LEFT AND RIGHT PRESSURE SENSORS
- Replace the Left and Right Pressure Sensors in accordance with the Service Information. Refer to SENSOR, IMPACT, REMOVAL
.
Clear DTC and retest for fault. Did the DTC return?
Yes
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the ORC in accordance with the Service Information. Refer to MODULE, OCCUPANT RESTRAINT, REMOVAL .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
No
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
- Replace the Left and Right Pressure Sensors in accordance with the Service Information. Refer to SENSOR, IMPACT, REMOVAL
.