LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Distribution >> Housing, HVAC >> Installation >> Housing - Fresh Air Inlet

Housing - Fresh Air Inlet

GC0096063Courtesy of CHRYSLER GROUP, LLC
NOTE:

The fresh air inlet housing must be removed from the vehicle for removal of the HVAC housing.

  1. Position the fresh air inlet housing (3), cabin air filter (1) and filter housing (4) as an assembly onto the engine compartment side of the dash panel (2).
  2. Install the two nuts (5) that secure the fresh air inlet housing and filter housing to the dash panel and tighten securely.
    GC0081035Courtesy of CHRYSLER GROUP, LLC
  3. Position the insulator (4) into its installed location and install the push-pin retainer (5) that secures the insulator to the front of the fresh air inlet housing (2).
  4. Install the push-pin retainer (1) that secures the fresh air inlet housing to the right inner fender (6).
  5. Reach under the fresh air inlet housing and install the wire harness retainer (3) into the bottom of the air inlet housing, if equipped.
    GC0081034Courtesy of CHRYSLER GROUP, LLC
  6. Position the Powertrain Control Module (PCM) or the Engine Control Module (ECM) (2) (depending on engine application) into its installed location.
  7. Position the strut tower support (3) into the engine compartment and loosely install the two bolts (1) that secure the strut tower support and the ECM/PCM to the passenger side strut tower (6).
  8. Install the purge solenoid (5) onto its mounting bracket located on the right strut tower.
  9. Engage the retainer that secures the wire harness (4) to the bottom of the strut tower support.
    GC0081033Courtesy of CHRYSLER GROUP, LLC
  10. Engage the wiper motor (5) to the bracket (4) located on the strut tower support (2).
  11. Position the strut tower support to the driver side and loosely install the two bolts (1) that secure the support to the strut tower.
  12. Tighten the strut tower support bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  13. Install the cowl top panel onto the dash panel. Refer to COVER, COWL PANEL, INSTALLATION .
  14. Connect the negative battery cable.
scientia non olet · About LEMON Manuals