LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Plumbing >> Evaporator, A/C >> Removal

Evaporator, A/C: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

GC0170440Courtesy of CHRYSLER GROUP, LLC
  1. Remove the HVAC housing assembly. Refer to HOUSING, HVAC, REMOVAL .
  2. Disassemble the HVAC housing as necessary to access the A/C evaporator (1). Refer to EVAPORATOR, A/C, REMOVAL .
  3. Carefully lift the A/C evaporator and the foam seal (2) out of the lower half of the HVAC housing (3).
    NOTE:

    If the foam seal at the front of the HVAC housing is deformed or damaged, the seal must be replaced.

  4. Remove the A/C expansion valve, tapping block and foam seal from the A/C evaporator. Refer to VALVE, A/C EXPANSION, REMOVAL .