LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Plumbing >> Line, A/C Discharge >> Removal

Line, A/C Discharge: Removal

WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

GC0158251Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the air cleaner housing. Refer to BODY, AIR CLEANER, REMOVAL .
  4. Reach through the headlamp opening in the upper radiator support and remove the nut (1) that secures the A/C discharge line (2) to the A/C condenser.
  5. Disconnect the A/C discharge line from the A/C condenser and remove and discard the dual plane seal.
  6. Install plugs in, or tape over the discharge line fitting and condenser inlet port.
    GC0158216Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    3.6L A/C compressor and refrigerant lines shown in the illustration.

  7. Remove the nut (2) that secures the A/C discharge line (1) to the A/C compressor.
  8. Disconnect the A/C discharge line from the A/C compressor and remove and discard the dual plane seal.
  9. Install plugs in, or tape over the opened refrigerant line fitting and the compressor port.
  10. Remove the A/C discharge line from the engine compartment.
scientia non olet · About LEMON Manuals