LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Emissions Control >> Evaporative Emissions >> Canister, Vapor >> Installation

Canister, Vapor: Installation

GC0081091Courtesy of CHRYSLER GROUP, LLC
  1. Install the rubber isolators into the vapor canister mounts.
  2. Position the vapor canister, ESIM, and fresh air filter into the vehicle as an assembly.
    GC0144608Courtesy of CHRYSLER GROUP, LLC
  3. Slide the vapor canister rubber isolators onto the mounting bracket.
  4. Raise the front of the vapor canister onto the mounting stud.
  5. Install the vapor canister retaining nut (1) and tighten securely.
    GC0144607Courtesy of CHRYSLER GROUP, LLC
  6. Connect the vapor purge line (3) quick-connect fitting to the EVAP canister.
  7. Connect the fuel tank vapor line (2) quick-connect fitting to the EVAP canister.
  8. Connect the ESIM electrical connector (1).
  9. Install the right rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
  10. Remove support and lower the vehicle.
  11. Install the fuel tank filler cap.
  12. Connect the negative battery cable.
  13. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals