LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Accessory Drive Belts >> Cooling System >> Supercharger System >> Pump, Coolant, Charge Air Cooler >> Installation >> Installation Non 6.2L Ho

Installation Non 6.2L Ho

GC0170111Courtesy of CHRYSLER GROUP, LLC
  1. Install the coolant hoses onto the coolant pump.
  2. Position the coolant pump onto the lower mounting bracket studs.
  3. Install the two lower mounting nuts and tighten the nuts (1) to the proper torque specifications. Refer to 3.6L TORQUE SPECIFICATIONS  or 5.7L/6.4L TORQUE SPECIFICATIONS .
  4. Install the coolant hose onto the auxiliary low temperature radiator and secure the clamp (2).
    GC0170071Courtesy of CHRYSLER GROUP, LLC
  5. Install the upper mounting nuts (1) and tighten to the proper torque specifications. Refer to 3.6L TORQUE SPECIFICATIONS  or 5.7L/6.4L TORQUE SPECIFICATIONS .
  6. Install the coolant hose onto the coolant tube and secure the clamp (2).
    GC0170484Courtesy of CHRYSLER GROUP, LLC
  7. Position the auxiliary low temperature radiator shroud (2) to the vehicle and install the fasteners (1).
  8. Connect the wire harness connector to the coolant pump.
  9. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
  10. Connect the negative battery cable.
  11. Evacuate air and refill cooling system. Refer to STANDARD PROCEDURE .
  12. Check cooling system for leaks. Refer to DIAGNOSIS AND TESTING .
scientia non olet · About LEMON Manuals