Starting System (Service Information): Starter: Installation: 3.6L

Courtesy of CHRYSLER GROUP, LLC

1. Position the starter (3) inside the transmission.
2. Install the starter mounting bolts (4) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
3. Connect the starter solenoid electrical connector (1) to starter solenoid terminal.
4. Install the battery cable and nut to the solenoid stud (2). Tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
5. Install the starter solenoid heat shield. Tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .

   Courtesy of CHRYSLER GROUP, LLC

6. Install the steering gear lower intermediate shaft (1). Refer to SHAFT, INTERMEDIATE, LOWER, INSTALLATION .
7. Remove the steering wheel holder.
8. Connect the negative battery cable and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .