LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Suspension & Wheel Alignment >> Front >> Knuckle, Steering, AWD >> Removal

Knuckle, Steering, AWD: Removal

NOTE:

Left side shown in illustration, right side similar.

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
    GC0170660Courtesy of CHRYSLER GROUP, LLC
  3. Remove the hub nut (1) from the axle shaft (2).
  4. Remove the front brake rotor. Refer to ROTOR, BRAKE, REMOVAL .
    GC0170809Courtesy of CHRYSLER GROUP, LLC
  5. Remove clip (1) fastening wheel speed sensor to knuckle.
  6. Remove screw (2) fastening wheel speed sensor to knuckle. Pull sensor head out of knuckle.
    GC0170837Courtesy of CHRYSLER GROUP, LLC
  7. Remove the outer tie rod end to knuckle nut (3).
    GC0079688Courtesy of CHRYSLER GROUP, LLC
  8. Using Puller (2), Special Tool (special tool #9360, Remover, Ball Joint), separate tie rod stud (1) from knuckle.
    GC0170737Courtesy of CHRYSLER GROUP, LLC
  9. Loosen the lower control arm to knuckle nut (2). Back nut off until nut is even with end of stud. Keeping nut on at this location will help keep end of stud from distorting while using Puller in next step. 
    GC0079690Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool, into place past seal boot.

  10. Using Puller (2), Special Tool (special tool #9360, Remover, Ball Joint), separate ball joint stud from knuckle.
  11. Remove tool.
  12. Remove nut (1) from end of ball joint stud.
    GC0177102Courtesy of CHRYSLER GROUP, LLC
  13. Loosen the upper control arm to knuckle nut (2). Back nut off until nut is even with end of stud. Keeping nut on at this location will help keep end of stud from distorting while using Puller in next step. 
    GC0079692Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool, into place past seal boot.

  14. Using Puller (2), Special Tool (special tool #9360, Remover, Ball Joint), separate upper ball joint stud (1) from knuckle.
  15. Remove tool.
  16. Remove nut (1) from end of upper ball joint stud.
  17. Slide knuckle off the half shaft and remove from vehicle.
    GC0170653Courtesy of CHRYSLER GROUP, LLC
  18. If hub and bearing and dust shield need to be removed:
    1. Remove the four hub and bearing to knuckle bolts (2).
    2. Slide hub and bearing out of knuckle along with shield.
scientia non olet · About LEMON Manuals